BulletPro 2 post 4.6 ton clear floor lift STD-6246TAD symmetrical or asymmetrical and motor high up design

The BulletPro STD-6246TAD can be installed with the columns positioned symmetrically or asymmetrically 

Great value for money. Reliable performance and Durable. Simple operation. Suitable for 4 x 4’s, vans , low cars, American cars, utes!

When the columns are installed in the symmetric configuration there is more drive through width between the columns. When the columns are installed in the asymmetrical configuration there will be more room to open car doors wider.

Overall height can be 4162 mm (Max height H1 height kit), 4062 mm, or lower height 3862 mm (H2 height kit) and 3552 mm (H height kit). Can be installed wide/ narrow/ high/ low depends on roof height.

Motor position high up in front of post, out of the way and save working space and can be closer to wall.

The column is designed for increased strength.

There is also high and low setting for the top cross bar depending on available roof height.

Special design allow minimum of 100 mm of high strength concrete is required for installation. Other models of lift needs 125 mm-150 mm concrete.

3 stage telescoping front arms, 2 stage rear arms, double screw up feet, low pad 88 mm minimum height.

Come with extension adaptorss and holders, protective rubber pads mounted to the carriage, rubber column guards, remote control and tool trays.

Supplied with a remote control to lift and lower onto locks helps when trying to position the arms under the vehicle.

Standard 3 phase motor, optional 240V motor

Features:

• 3 stage front arms and 2 stage rear arms with extension adaptors and holders to put adaptors on the post.
• Full length hydraulic cylinders with American seals.
• Top quality high speed motor & pump unit
• Remote control for up and lock.
• Asymmetric arm configuration to allow extra wide design for easy door opening
• Symmetric arm configuration to allow more drive thru width
• Dual cylinder lifting system with balance cables
• Lowering time 30-40 sec
• Lifting time 45-58 sec
• Tool Trays attached to each arm
• Safety shut down bar across top of hoist
• Ultra low arm design only 88 mm min height
• Rubber door protection pad
• A single manual control lever unlocks and lowers the lift
• Australian workcover registered

Specifications:

Capacity: 4600kg

Lift height: 1794 mm-1938 mm

Min Height: 88mm

Weight: 750KG

Power supply: standard 415V/3ph optional 220V/240V